Disco 2 frame ADVICE PLEASE !!!!

D2 rear frame has seen beter days I have pictures but I can't figure how to post them .anyhow has anybody fixed theirs ? Rovers north hasa replacement part 24 " long but as is always the case it comes up short by 10" .
So I turn to you all for advice I have put so much into this truck , heads and then a complete used engine and now this .

i've never repaired a frame. i know the brits do it all the time in order to pass MOT. as for posting pics, there is a ban on new members posting until they hit 5 posts. then follow the directions here.

https://nelrc.iftopic.com/t523-how-to-post-photos

Oh OK on the pics . I want to keep the truck but how much can ya keep dumping into it ,but then again beats a car payment .

you could always find a D2 truck that's lived it's life in the southwest and has a blown engine or some other catastrophic mechanical damage like a propshaft through the transmission, and make it a donor vehicle!

True been looking for one

What needs to happen? Welding? I'm not familiar with discos. Is that a common area for them to fail?

I think it is I have seen a lot of this on Craig's list its behind the wheels next to fuel tank .

How large of a area?

Its split 15 inches

Repair sections are availible for discos out of the UK check eBay...

Will do that eBay UK .

Just found repair panel from powerfuluk.com for £40.00 2mm thick plates that go over the old frame just have to figure out how much £40.00 is in our funny money .

$60 US. The pound is at a little less than 1.5 now.

Thanks I will be purchasing them would like to post it online before and after shots .

Mine has the same problem, Glad you put this thread up

Those brackets get welded in then, or bolted?

It comes to about 130 U.S.dollars but its still cheaper than a new frame !